APRS v1 Page 6

From whuckaba
Jump to: navigation, search

Back to APRS


So after some playing, it seemed the closest to the 1200/2200 I could get with single tones was using calibration value 127. This produced a 1207 hz low tone (using 1200 Hz only).
http://www.whuckaba.com/aprsproject/1200toneRF.JPG

Then 2200 tone gives 2212 Hz.

http://www.whuckaba.com/aprsproject/2200tonerf.JPG

But oddly when both tones are played, they deviate further.(1106,2313)
http://www.whuckaba.com/aprsproject/bothRF.JPG

To check if it was just a fact of that combo, I tested during a packet transmission, and the same results.
http://www.whuckaba.com/aprsproject/packet127.JPG


So I am tinkering and have found the closest I can get to a 1200 tone (as I would figure this would be the more important tone, is using cal 116).
http://www.whuckaba.com/aprsproject/cal117rf.JPG

Still a lot of noise, so I tried it directly from the tt3 to the pc. No real change.
http://www.whuckaba.com/aprsproject/cal117dr.JPG